Audio equalizer — Audio editor
Apply an audio EQ preset in the editor: voice clarity, more bass, more detail or balanced, with the exact frequency boosts listed.

What to know
The EQ tab is a preset selector rather than a set of sliders. It offers four choices: Balanced, Voice clarity, More bass and More detail, and each one is a fixed chain of filters that you can read in full.
Voice clarity cuts everything under 80 Hz with a high-pass filter, trims 2 dB around 180 Hz where a close microphone gets boomy, and lifts 4 dB around 2.8 kHz, the region that carries consonants. More bass adds 6 dB at 100 Hz and 2 dB at 250 Hz. More detail adds 4 dB at 5 kHz and 3 dB at 10 kHz. Balanced applies no filter at all, so the audio passes through unchanged.
Boosts raise peaks. A +6 dB lift multiplies the amplitude near 100 Hz by about 2, so a loud track can clip after More bass. If the result sounds crunchy, run the output through the Volume tab at 70 to 80 percent, or pick a different preset.
Because the editor also holds Trim, Speed, Volume, Fade and Mix, EQ usually sits in the middle of a chain: trim away the dead air first, EQ second, set the final level third.
There is no per-band control, so a preset that is almost right is still a preset. When you need a surgical cut at one frequency, treat these four as broad tone shapes only.
Choose a specific task 8
Related tools 5
How to use Audio equalizer — Audio editor
- Load a voice memo or a music track and open the EQ tab.
- Choose Voice clarity for a podcast or lecture, More bass for thin laptop recordings, or More detail for dull, muffled material.
- Set the export to WAV when more edits follow, or MP3 at 192 kbps for the final file.
- Process, compare the preview against the original, and download only if it sounds better.
Quick answers
Which frequencies does the Voice clarity preset change?
It high-passes at 80 Hz, cuts 2 dB at 180 Hz and boosts 4 dB at 2.8 kHz.
Can I drag individual EQ bands?
No. The EQ tab applies one of four fixed presets, so there are no sliders per frequency.
What does the Balanced preset do to the sound?
Nothing. It is a pass-through setting, which is handy for checking that a re-export alone keeps the tone.
Why did my file clip after More bass?
The preset adds 6 dB at 100 Hz, which roughly doubles the amplitude there. Lower the overall volume afterwards to leave headroom.
